295.09 And 295.10 Size Mismatch Jam (No Mix-Size) - Lexmark X95x series Service Manual

Step Action and questions
Check the connection of each
6
ADF controller card assembly
connector.
Is each connector of ADF
controller card assembly
connected properly?
Perform a POR.
7
Does the error remain when the
power is turned off/on?
Place an undamaged document
8
in the ADF, and perform an ADF
test.
Does the error remain?

295.01, 295.09 and 295.10 Size mismatch jam (no mix-size)

Step Action and questions
Check the document tray media
1
guide position.
Are the document tray media
guides set correctly?
Check the sensor (ADF
2
document tray width 1) for proper
operation.
th 3) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch ADF/SCANNER
SENSOR TESTS.
4. Touch Sensor (ADF
document tray width 1).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Check the sensor (ADF
3
document tray width 1).
Is the above component
properly connected?
Yes
Go to step 7.
Replace the ADF controller
PCBA.
Go to
"ADF controller PCBA
removal" on page 4-200.
Go to step 5.
Replace the RIP PCBA.
Go to
"RIP PCBA removal" on
page 4-150.
Yes
Go to step 2.
Go to step 4.
Replace the sensor (ADF
document tray width 1).
7558-xxx
No
Connect each connector of ADF
controller card assembly properly.
Problem resolved
Problem resolved
No
Adjust the document tray media
guides to the proper position.
Go to step 3.
Replace the connection.
Diagnostic information
Previous
Next
Go Back
2-163