Booklet Rear Tamper Guide Removal - Lexmark X95x series Service Manual

7558-xxx
Disconnect the connectors from the booklet paddle motor (A).
3.
4. Remove the two screws securing the booklet paddle motor (A) from the compiler frame.
Remove booklet paddle motor (A).
5.

Booklet rear tamper guide removal

1. Remove the booklet unit chassis. See
Remove the booklet unit motor assembly. See
2.
on page 4-323.
Remove the knife solenoid frame. See
3.
4. Remove the booklet media entrance drive motor. See
on page 4-326.
Remove the booklet knife sector drive gear 42T. See
5.
page 4-325.
Remove booklet unit gear train frame. See
6.
Remove the booklet unit assembly left cover. See
7.
page 4-331.
Remove the screw (A) securing the sensor (booklet rear tamper HP).
8.
Slide the booklet rear tamper guide out.
9.
Remove the e-clip.
10.
11. Remove the two springs (B) from the booklet rear tamper guide.
Remove booklet rear tamper guide.
12.
Service Manual
4-328
Left
"Booklet unit chassis removal" on page
"Booklet folding/exit drive motor assembly removal"
"Booklet fold solenoid frame removal" on page
"Booklet media entrance drive motor removal"
"Booklet knife sector drive gear 42T removal" on
"Booklet unit gear train frame removal" on page
"Booklet unit assembly left cover removal" on
A
Connector
4-332.
Previous
Next
Go Back
4-322.
4-333.