Sensor (Tray 5 Feed Out) Late Jam (80K Interval Exceeded For Feed Rollers) - Lexmark X95x series Service Manual

Step Action and questions
Check the sensor (tray 5 feed out)
3
for proper connection.
Is the above component
properly connected?
Check the HCF transport motor
4
for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch PRINTER MOTOR
TESTS.
4. Touch HCF transport motor.
Does the above component
operate properly?
Check the HCF transport motor
5
for proper connection.
Is the above component
properly connected?
Check the the HCF controller
6
card PCBA for proper connection.
Is the above component
properly connected?
POR the machine, and perform a
7
print test. Go to
"PRINT TESTS"
on page 3-25.
Does the error continue?

245.56 Sensor (tray 5 feed out) late jam (80K interval exceeded for feed rollers)

Step Action and questions
Check the media path.
1
Is the media path free of any
media fragments?
Check the feed rollers for wear.
2
Is the above component free of
excess wear and damage?
Yes
Clean or replace the sensor (tray
5 feed out). Go to
"HCF sensor
(tray 5 feedout) removal" on
page 4-440.
Go to step 6.
Replace the HCF transport motor.
Go to
"HCF transport motor
removal" on page 4-446.
Replace the HCF controller card
PCBA. Go to
"HCF controller
card PCBA removal" on
page 4-426.
Go to step 7.
Replace the upper printer engine
PCBA.
Go to
"Upper printer engine
PCBA removal" on page 4-186.
Yes
Go to step 2.
Go to step 3.
7558-xxx
No
Replace the connection.
Go to step 5.
Replace the connections.
Replace the connections.
Problem resolved
No
Remove any media or media
fragments.
Replace the feed rollers.
Go to
"HCF feed roll assembly
removal" on page 4-428.
Diagnostic information
Previous
Next
Go Back
2-129