Sensor (Front Tamper Hp) And Sensor (Rear Tamper Hp) Removals - Lexmark X95x series Service Manual

Remove the screw securing the bracket (B) to the media entrance pinch guide assembly (C).
9.
Connector
10. Release the hooks securing the sensor (finisher media entrance) (A) to the bracket (B).
Remove the sensor (finisher media entrance) (A).
11.

Sensor (front tamper HP) and sensor (rear tamper HP) removals

1. Remove the finisher front door assembly. See
Remove the rear upper cover. See
2.
Remove the rear lower cover. See
3.
Remove the upper media bin assembly. See
4.
Remove the upper media bin vertical cover. See
5.
6. Remove the stapler unit frame. See
Remove the media eject clamp motor assembly. See
7.
Remove the media eject unit assembly. See
8.
Remove the media eject motor assembly. See
9.
Remove the media compiler unit assembly. See
10.
page 4-362.
Disconnect the connector from the sensor (front tamper HP) (A) or the sensor (rear tamper HP) (B).
11.
12. Release the hooks securing the sensor (front tamper HP) (A) or the sensor (rear tamper HP) (B) from the
media compiler unit assembly (C).
A
Clamp
Left
"Finisher front door assembly removal" on page
"Rear upper cover removal" on page
"Upper media bin front cover removal" on page
"Upper media bin assembly removal" on page
"Right eject cover removal" on page
"Stapler unit frame removal" on page
"Media eject unit assembly removal" on page
"Media eject motor assembly removal" on page
"Media compiler unit assembly removal" on
B
C
4-377.
4-409.
"Clamp drive motor removal" on page
Repair information
7558-xxx
Previous
Next
Go Back
4-345.
4-420.
4-419.
4-378.
4-337.
4-367.
4-366.
4-389