Stapler Unit Frame Removal - Lexmark X95x series Service Manual

Remove the two screws securing the bracket (H) to the stapler unit assembly (F).
17.
Remove the stapler unit assembly (F).
18.
Reinstallation notes:
When replacing the stapler unit assembly (F), make sure the ground wire is reconnected.
•
• Make sure the stapler carriage assembly (D) and the stapler carriage motor assembly (C) move freely
without binding.

Stapler unit frame removal

1. Remove the finisher front door assembly. See
Remove the staple cartridge.
2.
3. Remove the rear upper cover. See
Remove the rear lower cover. See
4.
Loosen the four screws securing the plate (A) to the finisher.
5.
* 1
* 2
E
G
* 1
* 2
Connectors
"Rear upper cover removal" on page
"Upper media bin front cover removal" on page
F
H
D
Ground wire
"Finisher front door assembly removal" on page
7558-xxx
4-345.
4-377.
4-420.
Repair information
4-409
Previous
Next
Go Back