Stacker Bin Failure - Lexmark X95x series Service Manual

7558-xxx
Step Action and questions
Check the media eject clamp
5
clutch for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Media eject clutch.
Does the above component
make an audible clicking
noise?
Check the media eject clamp
6
clutch for proper connection.
Is the above component
properly connected?
Perform a POR.
7
Does the error continue when
the power is turned off/on?

381.12 Stacker bin failure

Step Action and questions
Check the vertical transport
1
mechanism of the stacker bin for
obstacles and damage.
Are the any obstacles in the
vertical transport mechanism
of the stacker bin?
Check the sensor (stacker bin
2
level encoder) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (stacker bin
level encoder).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Service Manual
2-178
Yes
Go to step 7.
Replace the media eject clamp
clutch. Go to
"Media eject clamp
clutch removal" on page 4-365.
Replace the finisher controller
PCBA. Go to
"Finisher PCBA
removal" on page 4-350.
Yes
Remove obstacles.
Go to step 4.
No
Go to step 6.
Replace the connection.
Problem resolved
No
Go to step 2.
Go to step 3.
Previous
Next
Go Back