Punch Carriage Shift Motor Assembly Removal - Lexmark X95x series Service Manual

7558-xxx
Remove the two screws on the front securing the punch carriage assembly (B) to the finisher.
12.
13. While moving the belt (buffer/transport) (E) to the left as shown, pull the punch carriage assembly (B)
gently out of the rear of the finisher.
Warning: Do not force the punch carriage assembly (B) out of the finisher. Be sure to hold the unit firmly to
avoid dropping it.
Reinstallation notes:
Warning: Make sure the punch carriage assembly is able to shift back and forth completely without binding the
harnesses, or damage will occur.
Do not force the punch unit into the finisher.
•
Be sure to hold the punch carriage assembly firmly to avoid dropping it.
•
• Make sure all harnesses are properly clamped.
Make sure the harnesses do not come into contact with any rotating mechanisms.
•

Punch carriage shift motor assembly removal

Open the finisher front door assembly.
1.
2. Remove the upper media bin assembly. See
Remove the top cover. See
3.
Remove the rear upper cover. See
4.
Remove the punch carriage assembly. See
5.
Remove the two screws securing the cover (A) to the punch carriage assembly (B).
6.
7. Remove the cover (A).
Service Manual
4-374
B
"Upper media bin assembly removal" on page
"Top cover removal" on page
"Rear upper cover removal" on page
"Punch carriage assembly removal" on page
Front
4-418.
4-377.
Previous
Next
Go Back
4-419.
4-372.