200.55 Sensor (Registration) Lag Jam - Lexmark X95x series Service Manual

Step Action and questions
Check the MPF feed/lift motor for
7
proper connection.
Is the above component
properly connected?
POR the machine, and perform a
8
PRINT test.
Go to
"PRINT TESTS" on
page 3-25.
Does the error continue?
POR the machine, and perform a
9
PRINT test.
Go to
"PRINT TESTS" on
page 3-25.
Does the error continue?

200.05/200.55 Sensor (registration) lag jam

Step Action and questions
Check the media path.
1
Is the media path free of any
media fragments?
Check the registration/transport
2
roller assembly.
Is the above component free of
excess wear and
contamination?
Check the 2nd transfer roller.
3
Is the above component free of
excess wear and
contamination?
Check the sensor (registration)
4
for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch PRINTER SENSOR
TESTS.
4. Touch Sensor (registration).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Yes
Replace the media transport/
MPF drive motor.
Go to
"Media transport/MPF
drive motor removal" on
page 4-124.
Replace the lower engine PCBA.
Go to
"Lower engine PCBA
removal" on page 4-104.
Replace the upper printer engine
PCBA.
Go to
"Upper printer engine
PCBA removal" on page 4-186.
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to Step 6.
7558-xxx
No
Replace the connection.
Problem resolved
Problem resolved
No
Remove any media or media
fragments.
Clean or replace the registration/
transport roller assembly.
Go to
"Registration/transport
roller assembly removal" on
page 4-149.
Clean or replace the 2nd transfer
roller.
Go to
"2nd transfer roller
removal" on page 4-28.
Go to Step 5.
Diagnostic information
Previous
Next
Go Back
2-93