Sensor (Rear Tamper Hp) Lag Jam - Lexmark X95x series Service Manual

7558-xxx

381.04 Sensor (rear tamper HP) lag jam

Step Action and questions
Check the tamper mechanism by
1
moving it manually.
Does the above component
slide back and forth properly?
Check the sensor (rear tamper
2
HP) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (rear tamper
HP).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Check the sensor (rear tamper
3
HP) for proper connection.
Is the above component
properly connected?
Check the rear tamper motor for
4
proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Rear tamper motor
(forward).
5. Touch Rear tamper motor
(rearward).
Does the above component
operate properly?
Check the rear tamper motor for
5
proper connection.
Is the above component
properly connected?
Perform a POR.
6
Does the error continue when
the power is turned off/on?
Service Manual
2-170
Yes
Go to step 2.
Go to step 4.
Replace the sensor (rear tamper
HP). Go to
"Sensor (front
tamper HP) and sensor (rear
tamper HP) removals" on
page 4-389.
Go to step 6.
Replace the media compiler
guide. Go to
"Media compiler
unit assembly removal" on
page 4-362.
Replace the finisher controller
PCBA. Go to
"Finisher PCBA
removal" on page 4-350.
No
Replace the media compiler unit
assembly. Go to
"Media
compiler unit assembly
removal" on page 4-362.
Go to step 3.
Replace the connection.
Go to step 5.
Replace the connection.
Problem resolved
Previous
Next
Go Back