Sensor (Adf Pre Registration) Lag Jam (Inverting) - Lexmark X95x series Service Manual

Step Action and questions
Check the ADF nip release
8
solenoid for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch ADF/SCANNER
MOTOR TESTS.
4. Touch ADF nip release
solenoid.
Does the above component
operate properly?
Check the ADF nip release
9
solenoid for proper connection.
Is the above component
properly connected?
Place an undamaged document
10
in the ADF, and perform an ADF
test.
Does the error remain?

282.15 Sensor (ADF pre registration) lag jam (inverting)

Step Action and questions
Check the media path.
1
Is the media path free of any
media or media fragments?
Check the ADF rollers for wear.
2
Is the ADF feed/pick roller
assembly or the ADF
separation roller guide free of
excess wear?
Check the sensor (ADF
3
registration) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch ADF/SCANNER
SENSOR TESTS.
4. Touch Sensor (ADF
registration).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Yes
Go to step 10.
Replace the ADF nip release
solenoid. Go to
"ADF nip
release solenoid removal" on
page 4-213.
Replace the ADF controller
PCBA. Go to
"ADF controller
PCBA removal" on page 4-200.
Yes
Go to step 2.
Go to step 3.
Go to step 5.
7558-xxx
No
Go to step 9.
Replace the connections.
Problem resolved
No
Remove any media or media
fragments.
Replace the ADF feed/pick roller
assembly. Go to
"ADF feed/pick
roller assembly removal" on
page 4-207.
Go to step 4.
Diagnostic information
Previous
Next
Go Back
2-143