Paper Skew - Lexmark X95x series Service Manual

Paper skew

The printed image is partially rotated as a result of the media not being fed straight into the device.
Step
Check printer installation placement.
1
Check the installation surface for irregularities.
Check for damaged printer caster.
Is the setup surface normal?
Properly load media into the media tray assembly and
2
ensure all guides are set correctly.
Properly install the media tray assembly into the printer.
Reprint the defective image.
Does the problem remain?
Check for obstructions in the area of the media feed
3
units.
Are the media feed unit assembly free from any
obstructions?
4 Is the printer left door assembly properly and evenly
closed?
Check the 2nd transfer roller for contamination and
5
wear.
Is the 2nd transfer roller free of excess wear and
contamination?
Check Yes No
Go to step 2. Correct the
installation
placement.
Go to step 3. Problem
resolved
Go to step 4. Remove
obstructions.
Go to step 5. Open, and then
properly close
the printer left
door assembly.
Go to step 6. Replace the 2nd
transfer roller.
Go to
"2nd
transfer roller
removal" on
page 4-28.
Diagnostic information
7558-xxx
Previous
Next
Go Back
2-279