Remove the two screws securing the bracket (B) to the finisher.
5.
Connector
Note: The upper media bin vertical cover (C) has slots that make access to the screws easier, as shown.
Right
Remove the bracket (B).
6.
Release the hooks securing the sensor (lower media exit) (A) to the bracket.
7.
Remove the sensor (lower media exit) (A).
8.
Sensor (media eject clamp HP) removal
Remove the rear upper cover. See
1.
Remove the upper media bin assembly. See
2.
Clamp
A
B
C
B
A
"Rear upper cover removal" on page
Access slots
"Upper media bin assembly removal" on page
7558-xxx
Front
4-377.
4-419.
Repair information
4-391
Previous
Next
Go Back