Disconnect the connector from the stepper motor (exit).
4.
A
Second
First
Remove the two screws securing the bracket (D) to the finisher.
5.
Remove the bracket (D).
6.
Remove the two screws securing the stepper motor (exit) to the bracket (D).
7.
8.
Remove the stepper motor (exit) (C).
Replacement notes:
The tension of the belt (exit) (B) is automatically adjusted by the force of the spring attached to the belt
•
tensioner bracket (A).
•
Tighten the two screws in the order shown.
B
A
D
C
Connector
Rear
C
Connector
Repair information
7558-xxx
Previous
Next
Go Back
4-415