Tray[X] Paper Out Sensor Test; Tank Receiver Test; Align Printer - Lexmark Pro910 Series Service Manual

Lexmark Pro910 Series
3.
The sensor's state changes.
Paper High in Tray [x]
Paper Low in Tray [x]
4.
Touch

Tray[x] Paper Out Sensor Test

To perform this test:
1.
From the Manufacturing Test menu, navigate to Tray[x] Paper Out Sensor Test.
2.
Load paper into the tray.
3.
The sensor's state changes.
Paper In in Tray [x]
Paper Out in Tray [x]
4.
Touch

Tank Receiver Test

This test verifies the communication between the printer and the chip embedded in each ink tank. This test only
checks communication and does not necessarily check for security.
To perform this test:
1.
From the Manufacturing Test menu, navigate to Tank Receiver Test.
2.
The result for each tank appears on the display.
•
If the printer is able to connect and to communicate with the tank the result is Passed.
•
If the printer is not able to connect with the tank, the result is Failed.
3.
Touch

Align Printer

This option aligns the printhead.
To perform this procedure:
1.
From the Manufacturing Test menu, navigate to Align Printer.
2.
Follow the instructions on the display.
3.
Touch
3-12
Service Manual
Result
When more than 30 sheets are detected by the sensor.
When 1–30 sheets are detected by the sensor.
or to cancel the test and return to the Manufacturing Test menu.
Result
When paper is detected by the sensor.
When paper is not detected by the sensor.
or to cancel the test and return to the Manufacturing Test menu.
or to cancel the test and return to the Manufacturing Test menu.
to cancel the test, and touch to return to the Manufacturing Test menu.
Previous
Next
Go Back