Factory Test; Clear Data; Sram Clear; Memory Clear - Konica Minolta bizhub C25 Service Manual

Field Service Ver. 1.1 May 2011

13.12 FACTORY TEST

• This test is for factory adjustment only and should NOT be used.
SIGNAL TEST
RELAY TEST
SENSOR TEST
DIAL TEST
VOLUME TEST
PANEL BUZZER TEST
RAM TEST

13.13 CLEAR DATA

13.13.1

SRAM CLEAR

A. Use
• The following items are cleared (initialization).
Menu mode (Except for [ADMIN. MANAGEMENT]
that keeps its setting value):
Only [USER SERVICE MODE] of the user service mode: Set to default.
Only [TX/RX Result] of the Display mode: Clear.
Only [SERVICE'S CHOICE] and [SOFT SWITCH] of the Service mode: Set to default.
B. Procedure
NOTE
• Before executing [SRAM CLEAR], be sure to record the setting values that are to
be initialized through [SRAM CLEAR].
• For the record of the setting values, it is a good idea to have reports and lists
printed.
• Some setting values are not included any of these reports or lists. Be sure to make
a note of them separately.
• After [SRAM CLEAR] has been executed, make necessary entries of data again
based on the setting values recorded.
13.13.2

MEMORY CLEAR

A. Use
• The following items are cleared (initialization).
Only [SERVICE'S CHOICE] and [FIXED ZOOM CHANGE] of the Service mode: Set to
default.
B. Procedure
NOTE
• Before executing [MEMORY CLEAR], be sure to record the setting values that are
to be initialized through [MEMORY CLEAR].
• For the record of the setting values, it is a good idea to have reports and lists
printed.
• Some setting values are not included any of these reports or lists. Be sure to make
a note of them separately.
• After [MEMORY CLEAR] has been executed, make necessary entries of data again
based on the setting values recorded.
• This test is for factory adjustment only and should NOT be used.
• This test is for factory adjustment only and should NOT be used.
• This test is for factory adjustment only and should NOT be used.
• This test is for factory adjustment only and should NOT be used.
• To check the volume of the speaker.
• To check the operation of the display and all indicators and buttons.
• When the panel buzzer test are finish, press the panel reset key twice.
• To test reading and writing of the memory.
13. SERVICE MODE
Functions/Use

[USER SETTING]

[DATE&TIME]
169