Konica Minolta bizhub C25 Service Manual page 367

20. FAX ERROR
(8) Error code: 0087
Definition Training attempt has failed because speed unit can not adjust to lower speed.
Solution 1.
2.
3.
4.
5.
(9) Error code: 0088
Definition Received DCN signal after sending out DCS signal.
Solution 1.
2.
3.
(10) Error code: 008B
Definition Receiver's protocol of DIS is received, but it is not compatible with our machine.
Solution 1.
2.
(11) Error code: 008D
Definition Receiver's protocol of DIS is received, but remote side can not receive document
temporary, may be cause by run out of paper or other reason.
Solution 1.
2.
(12) Error code: 008F
Definition Modem not ready to received V.34 data within 6 seconds after received CFR signal.
Solution 1.
2.
3.
(13) Error code: 0091
Definition Sending out DCS+TCF signal 3 times consecutively but no signal in response from
receiver.
Solution 1.
2.
3.
326
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the machine TX level. <*1>
Adjust the SOFT SW12 [6-7] to "11", while receiving 4 PPR, the speed will
down.
Change the machine TX speed to V.17, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Register the telephone number in machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Change the machine TX speed to V.33.6, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Contact with recipient, ask for refilling machine with paper.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine TX speed to V.17, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Field Service Ver. 1.1 May 2011