Konica Minolta bizhub C25 Service Manual page 360

Field Service Ver. 1.1 May 2011
(25) Error code: 0044
Definition Can not receive carrier /FSK signal within 6 sec. after sending MCF in ECM mode.
Solution 1.
2.
3.
4.
(26) Error code: 0045
Definition Can not receive any correct signal after sending RNR response with ERR signal.
Solution 1.
2.
3.
(27) Error code: 0046
Definition Receive incorrect signal when sending RNR which response with ERR signal.
Solution 1.
(28) Error code: 0047
Definition Can not receive correct signal after sending ERR signal.
Solution 1.
2.
3.
(29) Error code: 0048
Definition Can not receive correct signal after receive PPS_PRI_Q or PRI_Q, EOR_PRI_Q.
Solution 1.
2.
3.
(30) Error code: 0049
Definition Can not receive correct signal after sending PIP/PIN signal within 13 sec.
Solution 1.
2.
3.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, and then ask sender resend again.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Boost the TX level of sender's machine.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Boost the TX level of sender's machine.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Boost the TX level of sender's machine.
20. FAX ERROR
319