Received Incorrect Response After Sending Pps_Mps; Can Not Receive Any Response In Rr Response Procedure After Sending Pps_Mps; Received Dcn After Sending Pps_Mps; Receive Pin Signal After Sent Last Page Three Times - Konica Minolta bizhub C25 Service Manual

20. FAX ERROR
(58) Error code: 00E4
Definition At phase D, transmitting units out PPS_MPS 3 times consecutively but receive no
answer.
Solution 1.
2.
3.
4.
(59) Error code: 00E5
Definition

Received incorrect response after sending PPS_MPS.

Solution 1.
2.
(60) Error code: 00E6
Definition

Can not receive any response in RR response procedure after sending PPS_MPS.

Solution 1.
2.
3.
4.
(61) Error code: 00E7
Definition

Received DCN after sending PPS_MPS.

Solution 1.
(62) Error code: 00E8
Definition At phase D, transmitting units out PPS_EOP 3 times consecutively but receive no
answer.
Solution 1.
2.
3.
4.
5.
(63) Error code: 00E9
Definition

Receive PIN signal after sent last page three times.

Solution 1.
334
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Set SOFT SW21 [5] to "1" (T4 timer = 4.5 sec.)
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Field Service Ver. 1.1 May 2011