Konica Minolta bizhub C25 Service Manual page 352

Field Service Ver. 1.1 May 2011
Code
0047 Can not receive correct signal after sending ERR signal.
0048 Can not receive correct signal after receive PPS_PRI_Q or PRI_Q, EOR_PRI_Q.
0049 Can not receive correct signal after sending PIP/PIN signal within 13 sec.
Line energy over threshold last 60 sec. after MCF, and can not detect FSK or carrier signal
004A
in ECM mode.
004B Can not detect correct FSK signal even through detected FSK tone within 6 sec.
004C Handshake fail during re-train or between page in V.34 RX.
004E Receive DCN signal after sending DIS in V.34.
004F Remote side disconnected after sending ANSam in V.8 phase.
0050 Can not receive any correct signal after sending CJ signal in V.8 phase.
0051 Can not receive phase 3 signal after phase 2 within 20 seconds in V.34.
0052 Can not receive phase 4 signal after phase 3 within 20 seconds in V.34.
0053 Modem disconnect after phase 4 in V.34.
0054 Remote side disconnected after phase 4 in V.8.
0055 Receive incorrect signal after sending DIS signal in V.34.
0056 Modem disconnect after sending CFR in V.34.
0057 Can not detect image signal within 6 seconds after sending CFR.
0058 Can not detect image signal within 6 seconds after modem enter to primary phase in V.34.
005A Modem can not detect any correct ECM frame within 3 minutes in phase C.
005B Can not detect phase 5 signal after primary channel within 6 seconds.
005C Detect busy tone within control channel after phase C.
005D Modem can not detect any correct ECM frame within 12 sec. in phase C.
005E Can not detect control channel signal after received RCP frame within 6 seconds.
005F Can not detect silence after sending JM signal for polling TX function.
0060 There are no bulletin files to be polled in V.34.
0061 Machine can not detect V.21 or V.8 signal within 35 seconds.
0062 Modem disconnect in phase D after our side sending out flags sequence in control channel.
0063 Can not receive any flag sequence in control channel within 6 seconds in phase D.
Can not detect any control channel signal in phase D within 60 seconds even through
0064
energy still on the line.
0065 Can not detect any control channel signal within 60 seconds after detect silence in phase D.
0066 Can not receive T.30 signal or carrier after sending CFR in V.34.
0070 User press stop key within receiving.
0071 Memory full within receiving.
0072 Received EOR_Q Signal.
Possible Causes of Error.
20. FAX ERROR
311