Konica Minolta bizhub C25 Service Manual page 376

Field Service Ver. 1.1 May 2011
(64) Error code: 00EA
Definition Can not receive any response in RR response procedure after sending PPS_EOP.
Solution 1.
2.
3.
4.
(65) Error code: 00EB
Definition At phase D, transmitting units out PPS_EOM 3 times consecutively but receive no
answer.
Solution 1.
2.
3.
4.
5.
6.
(66) Error code: 00EC
Definition Received incorrect response after sending PPS_EOM.
Solution 1.
2.
(67) Error code: 00ED
Definition Can not receive any response in RR response procedure after sent out PPS_EOM.
Solution 1.
2.
3.
4.
5.
(68) Error code: 00EE
Definition At phase D, transmitting units out EOR_NULL 3 times consecutively but receive no
answer.
Solution 1.
2.
3.
4.
5.
(69) Error code: 00EF
Definition Received incorrect response after sending EOR_NULL.
Solution 1.
2.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, then resend again.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Set SOFT SW21 [5] to "1" (T4 timer = 4.5 sec.)
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Change the machine setting to ECM OFF, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, then resend again.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, then resend again.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Change the machine setting to ECM OFF, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
20. FAX ERROR
335