Konica Minolta bizhub C25 Service Manual page 368

Field Service Ver. 1.1 May 2011
(14) Error code: 0093
Definition Received DCN signal after sending out DCS signal for V.34.
Solution 1.
2.
3.
(15) Error code: 0094
Definition Time out during transmit ECM frame or RCP command.
Solution 1.
2.
(16) Error code: 009A
Definition Can not detect any signal after sending CI signal.
Solution 1.
2.
3.
(17) Error code: 009F
Definition Can not received any response from other side after sending PPS_EOM signal.
Solution 1.
2.
3.
4.
(18) Error code: 00A0
Definition User stop or cancel transmission job.
Solution 1.
(19) Error code: 00A1
Definition Document JAM within transmission.
Solution 1.
(20) Error code: 00AE
Definition Can not finished V.8 procedure or detect V.21 signal after CM signal within 30 sec-
onds.
Solution 1.
2.
3.
Resend the FAX again.
Register the telephone number in machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Change the machine setting to ECM OFF, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Clear JAM ERROR, then resend the FAX again.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
20. FAX ERROR
327