Error Code List; Reception - Konica Minolta bizhub C25 Service Manual

20. FAX ERROR

20.3 Error code list

20.3.1

Reception

Code
0001 Manual receive mode, nothing G3 signal received within 35 sec.
0003 Received DIS after sending DIS signal.
0004 Received DCN after sending DTC signal.
0006 Detect busy tone within receiving phase B.
0009 Can not receive any signal within 35 sec. in manual polling mode.
0010 Received DCN signal after sending DTC signal in polling RX.
0011 Can not receive any correct response after sending three DTC signal.
0012 Remote side password not match in polling RX/our side no any file to be polling.
0013 Can not receive carrier within 6 sec. after sending CFR in data phase C.
0014 Can not receive T.30 signal after sending FTT signal.
0015 Line polarity change within receiving phase B to D.
0016 Receive DCN signal after sending FTT signal.
0017 Can not receive any response from remote side after sending type of xxx_EOM signal.
0018 Can not detect energy within 6 sec. after sending FTT command.
0019 Received DCN signal after sending CFR signal.
001A No energy on line over 6 sec. within phase C before any corrected ECM frame.
001D Detect flag but nothing after CFR.
0020 Can not correct frame within 6 sec. or in no-ECM mode, one decoding line over 6 sec.
0021 File full.
Owing to noise interference on the line, receiving side can not receive correct data within
0022
specified time (no ECM).
0023 Received PWD error in RSD or upgrade F/W.
0024 TX and RX machine both are different machine ID in upgrade F/W.
0025 TX and RX machine both are different company ID in upgrade F/W.
0026 Remote monitor level error remote side can not access in upgrade F/W.
002A Line problem.
0030 Can not receive any signal within 6 sec. at phase D.
0031 Received incorrect signal at phase D (not EOP, MPS, EOM, DCS PPS_Q, PPS_Q, etc.).
0032 Can not receive carrier within 6 sec. after sending MCF or RTP, RTN signal.
0033 Received DCN signal at phase D within pages (not last page).
In non-ECM mode, when machine already received the data but next line data does not
0039
receive within 13.1 seconds.
003F Remote side TSI not define in machine one touch or speed dial directory.
0040 Can not receive carrier within 6 sec. after sending CTR.
0041 Can not receive carrier within 6 sec. after sending PPR.
0042 Can not receive correct signal after sending RNR signal.
0043 Receive incorrect signal at phase D in ECM mode.
0044 Can not receive carrier /FSK signal within 6 sec. after sending MCF in ECM mode.
0045 Can not receive any correct signal after sending RNR response with ERR signal.
0046 Receive incorrect signal when sending RNR which response with ERR signal.
310
Field Service Ver. 1.1 May 2011
Possible Causes of Error.