Konica Minolta bizhub C25 Service Manual page 354

Field Service Ver. 1.1 May 2011
Code
00BC Modem can not ready within 10 seconds after entering primary channel in V.34.
00BD Can not detect correct V.21 or JM signal after detected FSK frequency.
00BE Remote side no document to be polled after V8 handshaking.
00BF Capability no match.
00C0 Remote side disconnect before entering primary channel in V.34.
At phase D, transmitting units out EOP 3 times consecutively, but receive no answer from
00C1
receiving unit.
00C2 Remote side disconnect after sending out V.8 CM signal.
00C4 After sending MPS signal, the received is not one of MCF, RTN, PIP, PIN, RTP, DCN.
00C5 Received DCN signal after sending MPS signal.
00C9 At phase D, sending MPS 3 times consecutively, but no answer from receiving unit.
00CA After sending EOP signal, the received is not one of MCF, RTN, PIP, PIN, PRI-EOP, DCN.
00CB After sending EOP signal, the received is DCN signal.
00CC After sending EOM signal, the received is not one of MCF, RTN, PIP, PIN, RTP, DCN.
00CD At phase D, transmitting units out EOM 3 times consecutively, but receive no answer.
00CE At phase D, transmitting units out EOM, but receive DCN.
00CF Received incorrect signal after sending DTC signal for V.34 polling.
00D0 Received ERR signal after sending EOR_NULL.
00D1 Received incorrect response after sending PPS_EOP signal in V.34.
00D2 Received DCN after sending PPS_EOP signal.
00D3 Received DCN after sending PPS_NULL signal.
00D4 Received DCN after sending PPS_EOM signal.
00D5 T5 timeout.
00D8 Can not detect correct phase 3 signal for polling within 25 seconds.
00D9 Can not detect correct phase 3 signal after detect silence after phase 2.
00DA Can not detect phase 4 signal within 30 seconds or remote side hang up over 6 seconds.
00DB Can not received any T.30 signal within 15 seconds within phase 4.
00DC Received T.30 signal in phase 4 other than DCS, DIS or DTC.
00DE Remote side no SUB capability in V.34.
00E0 At phase D, transmitting units out PPS_NULL 3 times consecutively but receive not answer.
00E1 Received incorrect response after sending PPS_NULL.
00E2 Can not receive any response in RR response procedure after sending PPS_NULL.
00E3 Can not speed down to lower speed in non ECM mode.
00E4 At phase D, transmitting units out PPS_MPS 3 times consecutively but receive no answer.
00E5 Received incorrect response after sending PPS_MPS.
00E6 Can not receive any response in RR response procedure after sending PPS_MPS.
00E7 Received DCN after sending PPS_MPS.
00E8 At phase D, transmitting units out PPS_EOP 3 times consecutively but receive no answer.
00E9 Receive PIN signal after sent last page three times.
00EA Can not receive any response in RR response procedure after sending PPS_EOP.
00EB At phase D, transmitting units out PPS_EOM 3 times consecutively but receive no answer.
00EC Received incorrect response after sending PPS_EOM.
Possible Causes of Error.
20. FAX ERROR
313