Received Incorrect Response After Sending Eor_Eop; After Received Err, Our Side Can Not Received Response After Sending Eor_Eop Com; Received Incorrect Response After Sending Eor_Eom; 00Fa Received Err Signal After Sending Eor_Eom - Konica Minolta bizhub C25 Service Manual

Field Service Ver. 1.1 May 2011
(76) Error code: 00F6
Definition

Received incorrect response after sending EOR_EOP.

Solution 1.
2.
(77) Error code: 00F7
Definition After received ERR, our side can not received response after sending EOR_EOP
command.
Solution 1.
2.
3.
4.
5.
(78) Error code: 00F8
Definition At phase D, transmitting units out EOR_EOM 3 times consecutively but receive no
answer.
Solution 1.
2.
3.
4.
5.
(79) Error code: 00F9
Definition

Received incorrect response after sending EOR_EOM.

Solution 1.
2.
(80) Error code: 00FA
Definition Received ERR signal after sending EOR_EOM.
Solution 1.
2.
(81) Error code: 00FB
Definition Can not receive any response in RR response procedure after sending EOR_EOM.
Solution 1.
2.
3.
4.
5.
Change the machine setting to ECM OFF, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, then resend again.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, then resend again.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Change the machine setting to ECM OFF, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Change the machine setting to ECM OFF, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine setting to ECM OFF, then resend again.
Boost the TX level of sender's machine.
Boost the machine TX level. <*1>
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
20. FAX ERROR
337