Konica Minolta bizhub C25 Service Manual page 365

20. FAX ERROR
(55) Error code: 0065
Definition Can not detect any control channel signal within 60 seconds after detect silence in
phase D.
Solution 1.
2.
3.
4.
(56) Error code: 0066
Definition Can not receive T.30 signal or carrier after sending CFR in V.34.
Solution 1.
2.
3.
4.
5.
(57) Error code: 0070
Definition User press stop key within receiving.
Solution 1.
(58) Error code: 0071
Definition Memory full within receiving.
Solution 1.
2.
3.
4.
(59) Error code: 0072
Definition Received EOR_Q signal.
Solution 1.
2.
3.
324
Ask sender resend the FAX again.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Ask sender resend the FAX again.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Change the machine RX speed to V.17, and then ask sender resend again.
Boost the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Ask sender resend the FAX again.
Split the document into several copies at sender, and send them by several dif-
ferent times.
Print out the receiving data which was stored in the FAX memory or delete the
unnecessary data.
Reboot the machine.
Execute MEMORY CLEAR.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Reduce the TX level of sender's machine.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Field Service Ver. 1.1 May 2011