Douwe Egberts Cafitesse 100 Service Manual page 58

Service Manual Cafitesse 100
Cafitesse 110 with FRAPPE – with I2C Espresso interface board for Frappe (one bridge is
FRAPPE V2.9
# XXXXXXXXXXXX
All keys
Machine=#######
1=110/120, 2=old
UP
Down
Flow=## cc/sec
Min:50 Max:75
Up
Down
Pot=#########
1=disabl 2=enabl
Up
Down
Pot ratio=1:##
Min:12 Max:99
Up
Down
Pot volume=####
Min:40 Max:2000
Up
Down
Pot dosing=#####
1=cont 2=portion
Up
Down
Count pot in ###
1=cup 2=pot
Up
Down
Frappe vol=###.# cc/s
Min:1,0 Max:50,0
Up
Down
4 - 8
open, one is closed)
When the Frappé interface has been installed successfully, the
message display will show:
"FRAPPE V2.9"
XXXXXXXXXXXXX = Serial number
Up
'Machine = 110/120' - programming for facelift dispensers
'Machine = older' - programming for older dispensers
has no effect on further programming in this case
For flow calibration
Selection enables or disables pot specific settings hereunder
In case 'Pot = disabled' the upper push button is not active
Skipped when 'Pot = disabled' (pot delivery is not active)
cont = continous dosing until push button is released
portion = portioned delivery of a pot volume upon pressing the push
button
cup = the pot volume is counted as number of equivalent cup volumes
pot = the dosing is counted per pot volume
Dosing from concentrate without water
WARNING: Frappé must not be used if a mixer motor is installed.
Programming
07.2004