Service Manual Cafitesse 100
•
The dispenser may be installed on a flat,
even counter, table, base stand or on a
wall-mounted table.
•
If there are no even installation surfaces,
the dispenser must be aligned.
•
A minimum clearance of 5 cm (1.97 in)
must be maintained at the back panel of
the dispenser to ensure enough cooling.
•
2 packagings are supplied:
1. Standard dispenser
2. Country kit with national accessories.
•
Measure the water pressure (see chap. 2.4).
•
Measure the supply voltage.
•
Unpack the dispenser (see chap. 2.3).
•
Place the dispenser on a table.
•
Remove the operating panel cover (1), the
front cover (2), the housing cover (3) with
cooling compartment lid (4) and air duct (5)
(Fig. 3).
CAUTION:
When the front cover is made
of glass, there is the danger of
being injured due to incorrect
handling or breaking of the
glass.
•
Adhere the cooling compartment sticker of
the country kit on the inside of the cooling
compartment lid (4) (Fig. 3).
•
Lift the floater wire (7) from transport
position and place it above the operating
lever (6) of the float microswitch (Fig. 4).
07.2004
Installation / Putting into Operation
x x
x x
x
x x
x x
x x
x x
x
x
S T
O P
Fig. 3
Fig. 4
4
1
3
5
2
6
7
2 - 13