Service Manual Cafitesse 100
•
Mount the air duct.
•
Mount the housing cover .
CAUTION:
Make sure to connect the
ground connection to the
housing cover.
•
Guide the plug connections S05/A (1) of
the main cable harness (former dry running
protection), S03/2 and S03/3 (2) of the
cable harness switch through the square
opening (3) of the rear wall. (Fig. 14)
•
Fasten the new rear wall. (Kit water tank)
•
Connect the plug connection S05/A of the
main cable harness (former dry running
protection) to PIN 1 of the switch (4). (Fig. 14)
•
Connect the plug connections S03/2 to
PIN 2 and S03/3 ( 2 ) to PIN 3 of the switch
(3).
(Fig. 14)
•
Mount the heating switch to the rear wall.
•
Reconnect the power plug.
CAUTION:
Make sure that the heating
switch (2) at the rear wall of the
dispenser is switched off,
otherwise the dry running
protection would be activated.
(Fig. 14)
•
Switch on the power switch (5), and wait
until the boiler is filled and the float switch
switches off. (Fig. 15)
ATTENTION: Do not touch any parts that are
voltage-supplied.
ATTENTION: Check whether the pump unit
draws water. If not, slightly
press the hoses in order to
generate a pumping movement.
5A - 50
Functions - Water System
2
3
4
Fig. 14
OFF
ON
5
OFF
ON
POWER
Fig. 15
1
xxxxx
STOP
xxxxx
07.2004