Kit Water Tank - Douwe Egberts Cafitesse 100 Service Manual

Service Manual Cafitesse 100
A.7.2 Installation of the Kit Water Tank
General Notes:
• The kit must only be installed by qualified
service technicians.
• The parts must be cleaned before the
installation of the kit.
• Remove the packaging of the pump unit
before the tank is filled.
• If there is no water connection available or
the drinking water is of bad quality, the
tank of the dispenser can be modified for
manual filling.
WARNING: Check the quality of the
drinking water before installing
the kit.
WARNING: The tank may only be filled with
drinking water. The drinking
water has to be changed daily.
WARNING: The water tank may not be
exposed to sun-rays.
CAUTION: The water tank as well as the
pump unit have to be cleaned
daily.
• The boiler is filled from the tank via a hose
connection on the rear side of the
dispenser.
• When filling the boiler for the first time, the
heating must be switched off by means of
the switch (1) on the rear wall, in order to
prevent the actuation of the dry running
protection, which would be caused, since
the filling of the boiler by means of the tank
is slower than by means of the standard
inlet valve with water pipe pressure. (Fig. 1)
• If 'cafe cool' shall be delivered, the kit
water tank cannot be installed.
07.2004
Functions - Water System
1
Fig. 1
5A - 45