Service Manual Cafitesse 100
Putting the dispenser into operation on ferries
•
Dismount the overflow hose (1) provided by
the manufacturer. (Fig. 1)
•
Cut 365 mm (14.37 in) off from the hose
(piece goods).
•
Directly connect the boiler overflow
chamber (4) and the outlet of the overflow
tray (3) to the new hose (2). (Fig. 1)
•
Connect the outlet hose.
A table fixing is not provided by the
manufacturer. However, it is urgently
recommended depending on the local
conditions.
WARNING:
The dispenser only operates
up to the following maximum
tilts:
Tilt to the left and front:
each 12°, i.e. 130 mm (5.12 in)
Tilt to the right and to the rear
each 10°, i.e. 110 mm (4.33 in)
WARNING:
There is the danger of being
scalded by hot water. Keep
hands and other parts of the
body away from the delivery
area.
•
If the tilts exceed these values
- the water supply must be closed
- the dispenser must be switched off with
the main switch
- the boiler must be drained via the hot
water delivery tap
(place a sufficiently large container
underneath the hot water delivery tap)
•
If the tilt decreased again below the above
mentioned values:
- open the water supply
- switch the dispenser on.
2 - 18
Installation / Putting into Operation
4
2
3
Fig. 1
1
07.2004