Service Manual Cafitesse 100
•
Turn the thermostat regulator (7) clockwise
up to the stop, to the maximum
temperature of 95 °C (171 °F). (Fig. 10)
•
Ensure that the dispenser heats up and is
switched off. (Low temperature indicator (8)
extinguishes.). (Fig. 11)
•
In this case switch off the main switch (9)
of the dispenser, and disconnect the power
supply plug (Fig. 11).
•
Mount the back panel, the air duct and the
housing cover with the cooling compartment
lid.
•
Remove the foil from the front cover and
the splash panel.
•
Insert the advertising panel and the front
cover (10/11). (Fig. 11)
CAUTION:
When the front cover is made
of glass, there is the danger of
being injured due to incorrect
handling or breaking of the
glass.
•
Degrease the housing wall thoroughly at
which the card holder (12) is to be
installed. (Fig. 11)
•
For degreasing, it is recommended to use a
mixture of 50% isopropanol and 50% water.
•
Mount the card holder (12) to the
dispenser. (Fig. 11)
•
Insert the documents into the card holder.
CAUTION:
The last page of the Quick
Reference card (Cleaning Report)
has to be copied, has to be filled
in by the trained Cleaning Perso-
nal and has to be filed up.
•
Connect the power supply plug again.
•
Switch the dispenser on at the main switch
(9). (Fig. 11)
•
Programme the dispenser in accordance
with the customer's demands (see chap. 4).
Factory settings: see chap. 4.
2 - 16
Installation / Putting into Operation
7
Fig. 10
10/
11
8
xxxxx
OFF
ON
STOP
xxxxx
9
OFF
ON
POWER
Fig. 11
12
07.2004