Douwe Egberts Cafitesse 100 Service Manual page 56

Service Manual Cafitesse 100
Cafitesse 120 service device Programming Mode – with I2C Espresso interface board installed
PRESTO V2.9
# XXXXXXXXXXXX
All keys
Machine=#######
1=110/120, 2=old
Up
Down
Flow=## cc/sec
Min:50 Max:75
Up
Down
Prod(1)=########
1=norm,2=espr
Up
Down
Ratio(1)=1:##
Min:10 Max:99
Up
Down
Volume(1)=####
Min:20 Max:300
Up
Down
Dosing(1)=#####
1=cnt,2=rp,3=por
Up
Down
Prod(2)=########
1=norm,2=espr
Up
Down
Ratio(2)=1:##
Min:10 Max:99
Up
Down
Volume(2)=####
Min:20 Max:300
Up
Down
4 - 6
XXXXXXXXXXX = serial number
'Machine = 110/120' - programming for facelift dispensers
Up
'Machine = older' - programming for dispensers without facelift design
(basically the order of the push buttons 1 and 3 is reversed)
For flow calibration
Skipped when 'Machine = old', as it is always espresso
norm = regular coffee, no mixer motor activated
espr = espresso, mixer motor activated
Ratio setting for upper push button
If 'Machine =110/120' and 'Prod.(1) = normal',
then setting range: 'Min:40 Max:2000'
If 'Machine = 110/120' and 'Prod.(1) = normal'
cnt = continuous dosing until the push button is released
rp = delivery of repeated complete cup volumes until the push button
is released
por = delivery of a single cup volume upon pressing the push button
once
norm = regular coffee, no mixer motor activated
espr = espresso, mixer motor activated
Ratio setting for middle push button
If 'Prod.(2) = normal',
then setting range: 'Min:40 Max:2000'
(both bridges on interface board are open)
Programming
07.2004