Starter Relay Inspection - KYMCO DINK 125 Service Manual

18
. STARTING SYSTEM
DINK 50/125

STARTER RELAY INSPECTION

Release the rubber cap (1) and remove the nut
(2), then disconnect the start motor cable.
Turn the ignition switch to "ON".
Squeeze and hold the brake lever fully then
push the starter switch.
The coil is normal if the start MAG switch
clicks.
Release the rubber caps (1) and remove the
nuts (2), then disconnect the start motor cable,
battery positive cable and harness wire.
Disconnect the start MAG switch connector
(3) and then remove start MAG.
Connect a fully charged 12 V battery positive
wire to the relay switch Yellow/Red wire
terminal and negative wire to the
Green/Yellow wire terminal.
There should be continuity between the cable
terminals while the battery is connected, and
no continuity when the battery is
disconnected.
18-6