Carburetor (Dink 125) Assembly - KYMCO DINK 125 Service Manual

13
. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK
ASSEMBLY
Carburetor reassembly can be performed in
the reverse order of disassembly. When
reassembling, carefully observe the
following instructions.
＊
● Assemble the parts taking
consideration of their function.
● Before assembling, wash all of the
parts in a clean petroleum based
solvent.
● Replace O-rings and seals with new
ones.
● After cleaning, reinstall the pilot screw
to the original setting by turn the screw
in until it lightly seats, and then
backing it out the same number of
turns counted during disassembly.
(1) Spring
(2) Retainer
(3) Jet needle
(4) Piston valve
(5) Auto choke
(6) Auto choke seat/O-ring
(7) Needle jet
(8) Needle jet holder
(9) Float valve
(10) Float pin
(11) Float chamber
(12) Float chamber O-ring
(13) Float
(14) Main jet
(15) Heater
(16) Slow jet
(17) Casting enrichment valve
(18) Cover
(19) Spring
(20) Pilot screw
13-17
DINK 50/125