KYMCO DINK 125 Service Manual page 70

3
. INSPECTION/ADJUSTMENT
Used engine oil may cause skin cancer if
repeatedly left in contact with the skin for
prolonged periods. Although this is unlikely
unless you handle used oil on a daily basis, it
is still advisable to thoroughly wash your
hands with soap and water as soon as possible
after handling used oil.
Change the engine oil with the engine at
normal operating temperature and the scooter
on its center stand to assure complete and
rapid draining.
1. Remove the oil filler cap/dipstick (1) from
the right crankcase cover.
2. Place a container under the left crankcase.
3. Remove the oil drain plug (2) to drain the
oil.
4. Reinstall the drain plug and tighten the
drain plug to specification.
Oil drain plug torque:
25 N-m (2.5 kgf-m, 18lbf-ft)
5. Fill the crankcase with the recommended
grade oil and install the oil fill cap.
Oil capacity (after draining):
0.9 liter (0.95 US qt, 0.8 lmp qt)
6. Start the engine and let it idle for 2－3
minutes.
7. Stop the engine and check that the oil level
is at the upper level mark on the oil filler
cap/dipstick with the scooter upright on
firm, level ground. Make sure there are no
oil leaks.
＊
Let the engine and exhaust system cool
before working in those areas.
3-7
DINK50/125