Drive Belt Installation - KYMCO DINK 125 Service Manual

8
. DRIVE AND DRIVEN PULLEYS/
KICK STARTER
Remove the drive belt from the clutch/ driven
pulley.

DRIVE BELT INSTALLATION

Turn the driven pulley clockwise and lift it up
to expand the drive belt groove and then
install a new drive belt.
Set the drive belt on the drive pulley.
Install the drive pulley face, starting ratchet
and 12mm drive face nut, then tighten the
drive face nut.
Torque: 3.5～4.0kg-m
＊
When installing the drive face nut, make
sure that the tooth spaces of the drive
pulley face and starting ratchet align
with the teeth of the crankshaft.
8-27
Ratchet
Drive Face Nut
DINK 50/125
Clutch/Driven Pulley
Drive Belt
Drive Face
Drive Bolt