Drive Belt Inspection/Replacement - KYMCO DINK 125 Service Manual

8
. DRIVE AND DRIVEN PULLEYS/
KICK STARTER
DRIVE BELT
Remove the left crankcase cover. ( 9 -3)
INSPECTION
Check the drive belt for cracks, separation or
abnormal or excessive wear.
Measure the drive belt width.
Service Limit: 17mm replace if below
＊
Use specified genuine parts for
replacement.
REPLACEMENT
Remove the ten left crankcase cover bolts and
left crankcase cover. ( 9 -3)
Hold the clutch outer with the universal
holder and remove the 10mm clutch outer
nut and clutch outer.
Special
Universal holder
Hold the drive pulley with the holder and
remove the 12mm drive face nut.
Remove the starting ratchet.
Remove the drive pulley face.
E017
Clutch Outer
Universal Holder
Ratchet
Drive Face Nut
DINK 50/125
Clutch Outer Nut
Drive Face
8-26