Starter Clutch (Dink 125) Installation - KYMCO DINK 125 Service Manual

10
. A.C. GENERATOR/STARTER CLUTCH
INSTALLATION
Install the starter driven gear onto the
crankshaft.
Apply oil to the starter reduction gear shaft.
Install the starter reduction gear and shaft to
the right crankcase.
Install the flywheel onto the crankshaft by
aligning the key on the crankshaft with the
groove in the flywheel.
＊
Before installation, check and make sure
that the inside of the flywheel is not
contaminated.
Starter Driven Gear
Reduction Gear
Shaft
Groove
Key
DINK 50/125
Flywheel
10-10