Cylinder Head Installation - KYMCO DINK 125 Service Manual

6
. CYLINDER HEAD/VALVES
INSTALLATION
Install the cam chain tensioner slipper.
Install two dowel pins.
Install the new gasket.
Install the cylinder head.
Install the intake manifold and tighten the
two mounting nuts securely.
Install the thermostat and tighten the
mounting bolt securely.
Install the camshaft (refer to the
"CAMSHAFT" section in this chapter).
Install the camshaft holder (refer to the
"CAMSHAFT HOLDER" section in this
chapter).
Install and tighten the two cylinder head bolts
to the specified torque.
Torque: 1 kgf-m (10 N-m, 7.2 lbf-ft)
＊
Always first tighten the cylinder head
cap nuts and then tighten the bolts
between the cylinder and cylinder head
to avoid cracks.
6-15
Dowel Pins
Cam Chain Tensioner Slipper
Thermostat
DINK 50/ 125
Cylinder Head Gasket
Intake Manifold
Camshaft