Valve/Valve Guide Inspection - KYMCO DINK 125 Service Manual

6
. CYLINDER HEAD/VALVES
CYLINDER HEAD DISASSEMBLY
Remove the valve spring cotters, retainers,
springs, spring seats, oil seals and valves using a
valve spring compressor.
＊
• Be sure to compress the valve springs
with a valve spring compressor.
• Mark all disassembled parts to ensure
correct reassembly.
Special
Valve Spring Compressor

VALVE/VALVE GUIDE INSPECTION

Inspect each valve for bending, burning,
scratches or abnormal stem wear.
If any defects are found, replace the valve with a
new one.
Check valve movement in the guide.
Measure each valve stem O.D.
Measure each valve guide I.D.
Subtract each valve stem O.D. from the
corresponding guide I.D. to obtain the
stem-to-guide clearance.
Service limits: IN : 0.06mm replace if over
EX: 0.08mm replace if over
＊
If the stem-to-guide clearance exceeds
the service limits, replace the cylinder
head as necessary.
CYLINDER HEAD INPECTION
Check the spark plug hole and valve areas for
cracks.
Check the cylinder head for warpage with a
straight edge and feeler gauge.
Service Limit: 0.05mm repair or replace if
over
＊
If the stem-to-guide clearance exceeds
the service limits, replace the cylinder
head as necessary.
E040
Valve Cotter
Retainer
Spring Compressor Oil Seal
DINK50/ 125
Springs Springs Seat
Valve
6-26