Clutch/Driven Pulley Installation - KYMCO DINK 125 Service Manual

8
. DRIVE AND DRIVEN PULLEYS/
KICK STARTER
Set the driven pulley, driven face spring and
clutch assembly onto the clutch spring
compressor. Compress the tool and install the
39mm drive plate nut.
Tighten the 39mm nut to the specified torque.
Torque: 5.0～6.0kg-m
Special
Universal holder
CLUTCH/DRIVEN PULLEY
INSTALLATION
Install the drive belt on the clutch/driven
pulley and then install the clutch/driven
pulley onto the drive shaft.
Install the clutch outer.
Hold the clutch outer with the universal
holder.
Install and tighten the 14mm clutch outer nut.
Torque: 3.5～4.5kg-m
Special
Universal holder
8-35
E034
Clutch Outer
E017
Universal Holder
DINK 50/125
Clutch spring compressor
Clutch/Driven Pulley
Clutch Outer Nut