16
. BATTERY/CHARGING SYSTEM
BATTERY(DINK 125)
REMOVAL/INSTALLATION
The battery is in the battery box below seat.
1. Open the seat.
2. Remove the two screws and battery cover
(1).
3. Remove the four screws and then remove
the battery retainer (2).
4. Pull battery out to expose the terminal
leads
5. Disconnect the negative (-) terminal lead (3)
from the battery first, then disconnect the
positive (+) terminal lead (4).
6. Remove the battery from the battery box.
Battery installation:
Install in the reverse order of the removal.
*
When install the battery, first connect the
positive (+) cable and then negative (-)
cable to avoid short circuit.
(1)
(4)
DINK 50/125
(2)
(3)
16-6