KYMCO DINK 125 Service Manual page 230

10
. A.C. GENERATOR/STARTER CLUTCH
Install the flywheel onto the crankshaft with
the flywheel hole aligned with the
crankshaft woodruff key.
＊
The inside of the flywheel is magnetic.
Make sure that there is no bolt or nut
before installation.
Hold the flywheel with the universal holder
and tighten the flywheel nut.
Torque: 3.5~4.5kgf-m
Special
Universal Holder
Install the cooling fan.
Torque: 0.8~1.2kgf-m
Install the fan cover.
Install the right side cover.
10-15
Universal Holder
Cooling Fan
Fan Cover
DINK 50/ 125