Cylinder Head Cover (Dink 125) Removal/Installation - KYMCO DINK 125 Service Manual

6
. CYLINDER HEAD/VALVES
CYLINDER HEAD COVER
(DINK 125)
REMOVAL
Remove the two nuts (1) and four bolts (2),
then remove the cylinder head cover.
INSTALLATION
Install a new cylinder head cover O-ring and
install the cylinder head cover.
＊
Be sure to install the O-ring into the
groove properly.
Install and tighten the cylinder head cover
bolts and nuts to the specified torque in a
crisscross pattern.
Torque: 1.2 kgf-m (12 N-m, 8.6 lbf-ft)
DINK50/ 125
O-ring
6-6