Fuel Pump Removal; Fuel Pump Installation - KYMCO DINK 125 Service Manual

13
. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK

FUEL PUMP REMOVAL

Remove the met-in box.
Remove the frame body cover.
Remove the rear carrier.
Disconnect the fuel pump inlet, outlet and vacuum
tubes.
Remove the two fuel pump attaching bolts and the
fuel pump.

FUEL PUMP INSTALLATION

Install the fuel pump and secure it with the two
bolts.
Connect the fuel pump inlet, outlet and vacuum
tubes.
Install the seat, met-in box and frame center cover.
Measure the fuel pump output.
Start the engine and disconnect the fuel outlet tube
and place a clean container under the tube to check
the fuel output.
Output: 40cc/1700rpm/10 seconds.
Fuel Pump
Out Tube
Vacuum Tube
Outlet Tube
DINK 50/125
Bolts
Fuel Tank Tube
Container
13-42