Adjusting The Home Position - GRAPHTEC FC4200-50 Service Manual

7.8 Adjusting the Home Position

1. Set the DIP switch to adjustment mode and switch on power.
2. Hold down the [Next Page] key until the LCD displays the following:
3. Press the [Enter] key. The plotter starts reading the home sensor. The LCD screen will switch to display
the following:
4. Attach a pen-type magnifier to the cutter holder, and move to the home position using the position key.
After confirming the position, press the [Enter] key.
Note:
For more information on the mechanical dimensions of the home position, see the mechanism manufac-
turing specifications.
5. The plotter starts reading the home sensor again and returns to the display in 3. If the position is good,
press the [Enter] key to finish.
6. Switch off power, or proceed to the next adjustment.
Reference:
This adjustment does not affect the plotterʼs pen exchange adjustment.
FC4200-UM-251-03-9370
FORCE
F1
HOME ADJ.
PRESS ENTER KEY!!
F2
SPEED
FORCE
F1
MOVE HOME POINT
PRESS ENTER KEY!!
F2
SPEED
OFFSET
QUALITY
OFFSET
QUALITY
42
ELECTRICAL SECTION
F3
F4
F3
F4