Modify Projector Communication Settings; Add A Network Device - Christie CP42LH User Manual

Field
24 Hour Time
Adjust for Daylight Savings Time
Time Offset
Apply Time Adjustment
Enable NTP
NTP Server
Test NTP

Modify projector communication settings

You need Administrator or Service permissions to complete this procedure.
1. Tap Menu > Administrator Setup > Communications Configuration.
2. Complete these fields:
Field
Device Name
IP Address
Subnet Mask
Gateway
Apply
Serial Speed (Baud)
Serial Access
Ethernet Access
Enable
V2 /V3
Management IP
Download MIB to USB
Apply

Add a network device

You need Administrator or Service permissions to complete this procedure.
1. Tap Menu > Administrator Setup > Network Devices Setup.
2. Tap the checkbox.
CP42LH User Guide
020-101363-03 Rev. 1 (08-2016)
Description
Displays time in a 24-hour format
Automatically adjusts the time for daylight savings.
Adjusts the projector time.
Applies the time adjustment setting.
Turns Network Time Protocol (NTP) clock synchronization on.
The NTP server IP address.
Tests the NTP server settings.
Description
The name of the projector.
The IP address of the projector.
The subnet mask to which the address belongs.
The IP address for the network gateway.
Applies Ethernet settings.
The baud rate of the serial port. The default is 115200.
Grants access to serial connections.
Grants access to Ethernet connections.
Enables SNMP.
The SNMP protocol type. Contact Christie for the SNMP V3 user ID and
password.
The IP addresses where SNMP information and notifications are sent.
Sends the SNMP Management Information Base (MIB) file to a USB flash drive.
Applies SNMP settings.
View and Modify Projector Settings
48