Enabling high altitude setting
Enable high altitude mode when altitudes >/= 2000 m. The fan operates at high speed to ensure
sufficient air flow for high altitudes; however, the noise level of the projector is increased.
1. Select Menu > Configuration > High Altitude.
2. To swap, select ENTER.
Setting the projector communication
Enable the receivers and the wired keypad to communicate with the projector from the remote. The
front and top IR sensors receive transmissions from the IR remote. Keep the transmission path to
these sensors unobstructed for uninterrupted communications with the projector.
1. Select Menu > Configuration > IR Control.
2. To enable the top IR sensor, select Top.
3. To confirm the selection, select ENTER.
4. To enable the front IR sensor, select Front.
5. To confirm the selection, select ENTER.
6. To enable the signal from the HDBaseT Box, select HDBaseT.
7. To confirm the selection, select ENTER.
Enabling 12V Trigger
When enabled, the projector screen is automatically raised or lowered when the projector is turned
on or off. This function only works when the projector is connected to an electrical projector screen.
1. Select Menu > Configuration > 12V Trigger.
2. Select to turn on or off 12V trigger.
3. To confirm the selection, select ENTER.
Setting audio settings
Control audio settings.
1. Select Menu > Configuration > Audio Settings.
2. Select to audio mute or adjust the volume.
3. To confirm the selection, select ENTER.
Inspire Series 4K User Manual
020-002098-01 Rev. 1 (09-2023)
Copyright © 2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring system settings
56