Cylinder Head Cover And Gasket; Distributor - Mazda 626 MX-6 Workshop Manual

Revised 5/91
ON-VEHICLE MAINTENANCE (VALVE SEAL)
Timing belt
Install the timing belt. (Refer to TIMING BELT of ON-
VEHICLE MAINTENANCE.)
86U01X-053

Cylinder head cover and gasket

1 . Clean out used silicon sealant from the gasket and gasket
groove. '
2. Apply new silicon sealant to the back of the gasket.
3. Apply silicon sealant to the shaded areas shown in the figure.
4. Install the cylinder head cover.
Tightening torque:
6—8 N m (60—80 cm-kg, 52—69 in-lb)
86U01X-054

Distributor

1. Apply engine oil to the O-ring, and position it on
the distributor.
2. Apply engine oil to the blade.
3. Install the distributor into the rear housing.
4. Loosely tighten the distributor mounting bolt.
86U01X-039
Steps After Installation
1. Fill the radiator with the specified amount and type
of coolant.
2. Perform the necessary engine adjustments. (Re­
fer to TUNE-UP PROCEDURE.)
86U01X-055
1
(1988 626/MX-6)
1 - 2 7