Radiator Removal/Installation - Mazda 626 MX-6 Workshop Manual

RADIATOR
REMOVAL / INSTALLATION
1. Drain the engine coolant.
2. Remove in the sequence shown in the figure.
3. Install in the reverse order of removal.
Note
• Position the hose clamp in the original location on the hose.
• Squeeze the clamp lightly with large pliers to ensure a good fit.
CHECK FOR
THE FOLLOWING AND
REPAIR OR REPLACE
IF NECESSARY
1. CRACKS, DAMAGE,
OR WATER LEAKAGE
2. BENT FINS (REPAIR WITH
A SCREWDRIVER)
3. DISTORTED OR BENT
RADIATOR INLET
(70—100 cm-kg,
61—87 in-lb)
1. Coolant reservoir hose
2. ATF hose (ATX)
3. Cooling fan connector
4. Upper and tower radiator hose
Revised 3/91
RADIATOR
CAUTION
AFTER COOLING FAN AND/OR RADIATOR
COWLING INSTALLATION, ROTATE THE COOL­
ING FAN BY HAND AND VERIFY THAT THE FAN
BLADE DOES NOT TOUCH THE RADIATOR
COWLING. IF THE FAN TOUCHES THE COWL­
ING, ADJUST THE RADIATOR COWLING MOUNT­
ING POSITION.
5. Racfiator bracket
|
liS»;
3
86U03X-010
O 6 UOEX-OO8
'V ; g ill
(1988 626, MX-6) 3-7